混凝土搅拌车翻车现象频发是怎么回事？
混凝土搅拌车翻车现象频发是怎么回事？
What is the frequent turnover of concrete mixer truck?
在搅拌车发生的事故中，很大一部分都是翻车原因造成的，混凝土搅拌车属于专用车，它跟普通的货车是不一样的，很多人开得了大货车，驾驶搅拌车还是有点困难的，中科聚峰总部先说说它吧，搅拌车是近十年左右新兴起的一种车型，它的相对较高，跟普通货车的驾驶方法是有区别的。那么导致搅拌车翻车的具体原因有哪些呢？
In the accidents of mixer truck, a large part is caused by rollover. The concrete mixer truck is a special vehicle, which is different from the ordinary truck. Many people can drive a large truck, but it is still a little difficult to drive the mixer. Let's talk about it first in the headquarters of Zhongke Jufeng. The mixer is a new type of vehicle in the past ten years or so. Its center of gravity is relatively high, and it is ordinary There are differences in the way trucks are driven. So what are the specific reasons for the truck to overturn?
1.驾驶员的操作不当，搅拌车较高，且在行驶途中，搅拌罐是处于匀速转动的状态，假如遇到转弯或者路况不好的情况下，控制不好车速和转速就容易导致搅拌车翻车，新手搅拌车司机要掌握好车速。
1. If the driver's operation is improper, the center of gravity of the mixer is high, and the mixing tank is in a state of constant speed rotation during driving. If you encounter turning or bad road conditions, poor control of the speed and speed will easily cause the mixer to overturn. The novice mixer driver should grasp the speed.
2. 路况恶劣，搅拌车一般都是从搅拌站装上混凝土，再运送到建筑工地上去，由于混凝土对环境有污染，所以搅拌站一般都是建立在比较偏僻的地方，所以有的地方路况不是很好，搅拌车整车满载时，在驾驶过程中加上路况不好，稍不注意就有可能造成翻车，如果自己的驾驶技术不熟练，对于这种路况的活儿好不要接
Two The road conditions are bad. The mixer truck is usually loaded with concrete from the mixing plant and then transported to the construction site. As the concrete pollutes the environment, the mixing plant is generally set up in remote places. Therefore, the road conditions in some places are not very good. When the mixer truck is fully loaded and the road condition is not good during driving, it may cause rollover if you do not pay attention to it I'm not proficient in driving, so I don't have to take on the work in this kind of road condition
3. 怎么样才能避免翻车呢？搅拌车在重载时要注意，发动机转速好在1000-1400转/分范围内工作，这样发动机拥有大扭矩，在运送混凝土的过程中，车速好控制在40km/h，这样才能大程度的保证行车，在转弯之前要将车速降下来，然后再转弯，搅拌车在装运搅拌好的混凝土时，搅拌罐的转速为2-10转/分，在运输过程中，比较平坦的额路面上搅拌罐的转速要保持在2-3转/分，行驶在侧倾坡大于50度的路面，或左右晃动较大的路面时，应停止搅拌罐转动，等路况好转后在恢复转动。
3. How to avoid rollover? When the mixer truck is under heavy load, it should be noted that the engine speed should be within the range of 1000-1400 rpm, so that the engine has a large torque. In the process of transporting concrete, the speed should be controlled at 40km / h, so as to ensure the driving to a large extent. Before turning, the speed of the mixing tank should be 2-10 when the mixing truck is transporting the mixed concrete In the process of transportation, the rotation speed of the mixing tank should be kept at 2-3 rpm on the relatively flat road surface. When driving on the road with a roll slope greater than 50 degrees, or on the road with large left-right shaking, the rotation of the mixing tank should be stopped, and the rotation can be resumed after the road conditions improve.
感谢您的阅读，希望对您有所帮助！如想了解更多内容欢迎点击中科聚峰总部https://www.jfjiaobanche.com网站。
Thank you for your reading and hope it can help you! If you want to know more, please click the headquarters of Zhongke Jufeng https://www.jfjiaobanche.com Website.
