自动上料搅拌车出车前的检查事项有哪些？
1.确认自动上料搅拌车搅拌罐处于停止状态，因为发动机启动时万一罐子处于高速旋转状态，瞬间的力会很大的，会损伤减速机。
1. Make sure that the mixing tank of the automatic feeding mixer is in the stop state, because if the tank is in the high-speed rotation state when the engine is started, the instantaneous force will be great and the reducer will be damaged.
2.要保证水箱里有足够的水，有减水剂，因为各种原因料太干，没有水添加放不出料的时候，减水剂就是救命稻草了。
Water reducing agent is not enough when adding water reducing agent into the water tank.
3.自动上料搅拌车点火之前先检查机油、防冻液、润滑油和冷却水等，发现不足时，应重新进行添加。
3. Check the engine oil, antifreeze, lubricating oil and cooling water before the ignition of the automatic feeding mixer, and add them again if they are insufficient.
4.还要检查自动上料搅拌车的灯光，尤其是腰灯，务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是较为薄弱的。
4. Also check the light of the automatic feeding mixer, especially the waist light. Make sure that the light is shining on the edge of the tire. The construction site will often stack reinforcement and other things, and the sidewall is relatively weak.
5.还应用抹布擦干净两边的后视镜、窗户玻璃，工地路况复杂，光线不好，视线一定要有保证。
5. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions on the construction site are complex and the light is not good. The line of sight must be guaranteed.
6.车子启动后，让罐子低速旋转，围绕着车检查轮胎气压，是否有漏气的胎，再用螺丝刀剔掉在胎缝里的石子。
6. After the car starts, let the jar rotate at a low speed. Check the tire pressure around the car to see if there is a flat tire. Then use a screwdriver to remove the stones in the tire seams.
下一篇：自上料搅拌车行驶中水温过高怎么办？上一篇：混凝土搅拌车卸料时的注意事项！
