新买的自上料搅拌车使用注意
现在自上料搅拌车的市场需求量很大，很多购买搅拌车的人对新购搅拌车的保养却不是很清楚，自上料搅拌车的保养还是很重要的。下面自上料搅拌车厂家来讲讲新买的自上料搅拌车使用注意事项。
At present, the market demand for self loading mixers is very large. Many people who buy mixers are not very clear about the maintenance of newly purchased mixers. The maintenance of self loading mixers is still very important. Next, the manufacturer of the self feeding mixer will talk about the precautions for the use of the newly purchased self feeding mixer.
新车都是有磨合期的，磨合是延长自上料搅拌车使用寿命的基础，一定要按说明书上的规定进行磨合。油净、水净、气净和机体净。柴油是搅拌车发动机的主要燃料，如果柴油不纯净，会使配合机体磨合，配合间隙增大，造成漏油，滴油，供油压力降低，间隙变大，甚造成油路堵塞，抱轴烧瓦等严重故障。
All new vehicles have a running in period. Running in is the basis for extending the service life of the self feeding mixer, and it must be carried out according to the specifications in the manual. Oil purification, water purification, gas purification and body purification. Diesel oil is the main fuel for the engine of the mixer truck. If the diesel oil is not pure, it will make the mating body run in, increase the mating clearance, cause oil leakage, oil dripping, oil supply pressure reduction, increase the clearance, and even cause serious failures such as blockage of the oil circuit, holding the shaft and burning the pads.
若空气中含有大量尘土，将会加速缸套、活塞和活塞环的磨损。若冷却水不纯净，会使冷却系水垢堵塞后，妨碍发动机散热，润滑条件也差，机体磨损严重。若机体外表不干净，会使表面受到腐蚀，缩短使用寿命。柴油和空气中供应不及时或中断，就会出现启动困难，燃烧不良，功率下降，发动机不能正常运转等现象。若冷却水供应不足就会使机温过高，功率下降磨损加剧，降低使用寿命。
If there is a lot of dust in the air, the wear of cylinder liner, piston and piston ring will be accelerated. If the cooling water is not pure, it will block the cooling system scale, hinder the engine heat dissipation, have poor lubrication conditions, and wear the engine body seriously. If the body surface is not clean, the surface will be corroded and the service life will be shortened. If the supply of diesel oil and air is not timely or interrupted, there will be difficulties in starting, poor combustion, power reduction, and abnormal engine operation. If the cooling water supply is insufficient, the machine temperature will be too high, the power will drop, and the wear will increase, reducing the service life.
自上料搅拌车因柴油机使用的过程中受震动冲击和负荷不均匀等影响，螺栓，螺母容易松动。还有各部位的调整螺栓都要检查，以免造成因松动而损坏机体的事故。
The bolts and nuts of the self loading mixer are easy to loosen due to the impact of vibration and uneven load during the use of the diesel engine. The adjusting bolts of all parts shall be checked to avoid the accident of damage to the engine body due to looseness.
柴油机的气门间隙、配气相位、共有提前角、喷油压力以及点火正时等都应及时检查并调整，以保证发动机经常处于良好的技术状态，方能节省燃油，延长使用寿命。
The valve clearance, valve timing, common advance angle, injection pressure and ignition timing of the diesel engine shall be checked and adjusted in time to ensure that the engine is always in good technical condition, so as to save fuel and prolong its service life.
自上料搅拌车行驶前，应使各瓦轴等润滑部位得到润滑。启动后应待水温达到40℃-50℃时再投入到作业，严禁长时间超负荷或低速作业。停机前，应先卸掉负荷降低转速。
Before the feeding mixer truck is driven, all bearing shafts and other lubricating parts shall be lubricated. After startup, it shall be put into operation when the water temperature reaches 40 ℃ - 50 ℃. Overload or low-speed operation for a long time is strictly prohibited. Before shutdown, unload the load and reduce the speed.
总之，细致的保养能够有效的延长搅拌车的使用寿命，各个部件在自上料搅拌车上起着举足轻重的作用，所以定期对搅拌车部件的检查也不能缺少，更多相关内容就来我们网站https://www.jfjiaobanche.com咨询了解吧！
In a word, careful maintenance can effectively extend the service life of the mixer. Each component plays a decisive role in the self feeding mixer, so regular inspection of the mixer components can not be lacking. More relevant information can be found on our website https://www.jfjiaobanche.com Ask and understand!
下一篇：搅拌车频发事项原因之车辆本身要素上一篇：关于搅拌车的轴承制作工艺
