搅拌车对预拌混凝土的输送
任何预拌混凝土在未添加缓凝剂的情况下，都在1小时左右进入初凝状态，这时再进行混凝土浇注施工将影响混凝土的工程质量。因此搅拌车运送预拌混凝土有其时间控制的输送半径。一般控制在1小时以内。从出料到卸料完毕的长时间为90分钟，且搅拌筒总转数不大于300转。如嫌原有的卸料槽不够长，需另外接长时，请用支柱将接长部分撑住。
Any ready-mixed concrete will enter the initial setting state within about 1 hour without adding retarder, and then the concrete pouring construction will affect the engineering quality of concrete. Therefore, the mixing truck has its time-controlled conveying radius for transporting ready-mixed concrete. It is generally controlled within 1 hour. The long time from discharging to discharging is 90 minutes, and the total number of revolutions of mixing drum is not more than 300. If the original discharge chute is not long enough and needs to be extended additionally, please support the extended part with a strut.
混凝土出料完毕后，应迅速对拌筒内部进行冲洗。
After the concrete is discharged, the inside of the mixing drum shall be washed quickly.
自上料搅拌车厂家注意：如不及时冲洗，不仅会造成拌筒内混凝土的粘结，使装载量减少，进料不畅，还会给机构带来故障，是事故的诱发因素。
Note from the manufacturer of self-feeding mixer truck: if it is not washed in time, it will not only cause the binding of concrete in the mixing drum, reduce the loading capacity, and make the feeding not smooth, but also cause the failure of the mechanism, which is the cause of the accident.
务必注意!空车行驶时，拌筒应以与搅动行驶同样的转速回转。注意：搅拌车行驶时，如搅拌停止回转，则拌筒滚道与筒托轮上会产生压痕，并发生异常噪声。因此，务请注意。
Be careful! When the truck is running empty, the mixing drum shall rotate at the same speed as the stirring driving. Note: When the mixing truck is running, if the mixing stops rotating, there will be indentation on the mixing drum raceway and drum supporting wheel, and abnormal noise will occur. Therefore, please pay attention.
开启供水装置的气压开关;
Turn on the air pressure switch of the water supply device;
用水枪冲洗时，请开启阀门;
Please open the valve when washing with water gun;
冲洗进料斗、出料斗、叶片时，请开启阀门;
Please open the valve when flushing the inlet hopper, outlet hopper and blade;
加水或排水时请开阀门;
Please open the valve when adding water or draining water;
关闭供水装置的进气开关，打开排气阀，使水箱与大气相通，即可向水箱内加水。使用压力水箱中的水冲洗时，先关闭排气阀，再打开气源进气阀门即可(详见产品上操作说明)。
Close the air inlet switch of the water supply device and open the exhaust valve to connect the water tank with the atmosphere, and then add water to the water tank. When using the water in the pressure water tank for flushing, close the exhaust valve first, and then open the air inlet valve of the air source (see the operating instructions on the product for details).
在冬季车辆停用时，请将水箱、管路和水枪中的余水全部排净，以免冻坏供水系统零件，造成不必要的损失。更多相关内容就来我们网站https://www.jfjiaobanche.com咨询吧！
When the vehicle is out of service in winter, please drain all the remaining water in the water tank, pipeline and water gun to avoid damaging the water supply system parts and causing unnecessary losses. Come to our website for more relevant content https://www.jfjiaobanche.com Ask!
