搅拌车从出车到卸料的全程关注事项
出车前的检查：
Inspection before departure:
混凝土自上料搅拌车厂家提醒，千万不能搅拌车坏在路上，否则出现闷罐就麻烦了，混凝土一般停罐不能超过2个小时，C40以上级别的混凝土基本就不能停。
The manufacturer of the concrete self-feeding mixer truck reminded that the mixer truck must not be broken on the road, otherwise it would be troublesome if the tank is blocked. Generally, the concrete can not be stopped for more than 2 hours, and the concrete of grade C40 or above can not be stopped.
点火之前先检查机油、防冻液、润滑油和冷却水等，发现不足时，应重新进行添加。
Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, etc., and add them again in case of any shortage.
车子启动后，再让罐子低速旋转，围绕着车检查轮胎气压，看是否有漏气的胎，检查是否有石子、铁钉之类扎在胎里。
After the car is started, let the can rotate at low speed, and check the tire pressure around the car to see if there is a leaking tire, and check whether there are stones, nails, etc. stuck in the tire.
检查灯光，尤其是腰灯。务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是薄弱的。
Check the light, especially the waist light. Make sure to look at the edge of the tire. The construction site will often pile up reinforcement and other things, and the tire side is weak.
用抹布擦干净两边的后视镜，窗户玻璃，工地路况复杂，光线不好，视线一定要保证。
Clean the rearview mirror and window glass on both sides with a rag. The road conditions on the construction site are complex and the light is poor. The sight must be guaranteed first.
装料时的清洁：
Cleaning during loading:
车辆大多是露天停放，罐里可能会有积水、树叶等杂物，如不排出将影响混凝土质量。
Most vehicles are parked in the open air, and there may be water, leaves and other debris in the tank. If not discharged, the concrete quality will be affected.
洗完后要关掉水箱进气口，打开水箱排气口排掉气体，因为气压下水管连接不好的地方容易渗水，影响其他车辆的。
After washing, turn off the air inlet of the water tank and open the air outlet of the water tank to drain the gas, because the place where the pneumatic downpipe is not connected properly is easy to seep, affecting the safety of other vehicles.
再次检查轮胎有无石子铁钉，因为停车时轮胎与地面接触的地方是检查不到的。
Check the tire again for stones and iron nails, because the contact between the tire and the ground cannot be checked when parking.
卸料时的细节：
Details when discharging:
1、卸料前让搅拌罐全速运转一两分钟
1. Let the mixing tank run at full speed for one or two minutes before discharging
让混凝土充分搅拌，必要时可以加一些水，让混凝土搅拌得更均匀，也方便卸料。
Allow the concrete to be fully mixed, and add some water if necessary, so that the concrete can be mixed more evenly and it is also convenient for unloading.
2、放料前先把出料斗溜槽打湿
2. Wet the discharge hopper chute before discharging
把车尽量停在平地上，放料前先把出料斗溜槽打湿，方便清洗。
Park the car on the flat ground as much as possible, and wet the chute of the discharge hopper before discharging to facilitate cleaning.
3、卸料不要大意和放料工打好关系
3. Don't be careless in discharging and keep good relationship with the discharging worker
放料时好自己看着，免得放料工乱操作放料操作杆。每次罐子正反转中间位子时好停一下，保护减速机、托轮等。
Keep an eye on yourself when discharging, so as to prevent the discharging worker from randomly operating the discharging lever. Each time when the can is in the middle position, stop to protect the reducer and supporting wheel.
与放料工打好关系，卸料时也不要睡的太熟，万一工人闹情绪，把你车子放到工地不转罐子，造成闷罐就麻烦了。
Keep a good relationship with the discharging workers, and don't sleep too fast when discharging. In case the workers are in a bad mood and put your car on the construction site without turning the can, it will cause trouble to suffocate the can.
洗罐子时一定要仔细冲洗干净，并把水反复正反转两次，再放出来。后一趟时把水箱的水全部放进罐子，再回到站加水清洗罐子。更多相关内容就来我们网站https://www.jfjiaobanche.com咨询吧！
When washing the can, be sure to wash it carefully, and turn the water forward and backward twice before releasing it. In the next trip, put all the water in the tank into the tank, and then return to the station to add water to clean the tank. Come to our website for more relevant content https://www.jfjiaobanche.com Ask!
下一篇：搅拌车零部件损坏后的维修策略上一篇：搅拌车磨合期期间保养的基本要求与注意
