搅拌车磨合期期间保养的基本要求与注意
刚买回来新的搅拌车,磨合期的保养非常重要,磨合期保养做好了,会延长搅拌车使用寿命。好的开始,是成功的一半。新车在磨合期间内,做好各方面小细节的保养,不要觉得是一些小毛病就不注意。其实混凝土自上料搅拌车的小毛病也要及时保养,下面混凝土自上料搅拌车厂家为您讲解。
The maintenance during the running-in period is very important for the newly purchased mixer truck. If the maintenance during the running-in period is completed, the service life of the mixer truck will be extended. A good start is half the battle. During the running-in period of the new car, do a good job of maintenance in all aspects and details. Don't think it's just a few small problems and don't pay attention to them. In fact, the small defects of the concrete self-loading mixer should also be maintained in time. The manufacturer of the concrete self-loading mixer will explain to you.
磨合期期间保养的基本要求
Basic requirements for maintenance during running-in period
一、减小车辆所运东西的质量:翅汽车在磨合期内装载量不能超过额定载荷的75%。新车在装载时应低于规定的载重或人数,更不能超载,因为超载会加重发动机、变速器、传动系统、悬挂系统等部件的负担,加重磨损，对车辆造成损害。
1、 Reduce the mass of the goods carried by the vehicle: the load of the wing vehicle during the running-in period shall not exceed 75% of the rated load. When loading a new car, it should be lower than the specified load or number of people, let alone overloading, because overloading will increase the burden of engine, transmission, transmission system, suspension system and other components, increase wear, and cause damage to the vehicle.
二、使用质量良好的润滑油:选择低黏度和优良润滑油,能使摩擦表面得到良好的润滑,减缓机件磨损。
2、 Use high-quality lubricating oil: select low viscosity and excellent lubricating oil, which can make the friction surface well lubricated and reduce the wear of machine parts.
磨合期保养应该注意的一些事项
Precautions for maintenance during running-in period
一、先对车子进行预热,冷启动时,好等水温预热到40度以上再起步。搅拌车起步时应轻踩慢抬离合器和加速踏板,并选择良好的路面行驶。凉车时候也不要猛踩油门]。
1、 Warm up the car first. When starting cold, wait for the water temperature to warm up to above 40 degrees before starting. When the mixer starts, gently step on the clutch and accelerator pedal, and select a good road to drive. Don't step on the accelerator when the car is cold].
二、控制好搅拌车的速度,处于磨合期的搅拌车,一定要控制好驾车的速度,不能速度太高,时速好控制在50--80/时。在开过1500后可逐渐把转速和车速提高到车辆允许的高速度,而且不要用力踩油门，以保证活塞、汽缸及其它-些重要的部件在缓和的状态下提高负荷。
2、 Control the speed of the mixing truck. For the mixing truck in the running-in period, it is necessary to control the driving speed. The speed should not be too high. The speed should be controlled at 50-80 km/h. After driving 1500 kilometers, the speed and speed can be gradually increased to the allowable high speed of the vehicle, and do not step on the accelerator hard to ensure that the piston, cylinder and other important components increase the load in a relaxed state.
三、开车时档位要勤换,不要长时间使用一个挡位,起步时先挂低档,然后逐步换为高挡,循序渐进地行驶。低挡高速，高挡低速的现象一定要避免,这样会减小发动机的使用寿命。
3、 When driving, shift gears frequently. Do not use one gear for a long time. When starting, first shift to low gear, then gradually shift to high gear, and drive gradually. The phenomenon of low gear high speed and high gear low speed must be avoided, which will reduce the service life of the engine.
四、制动分离合,小型搅拌车在制动的时候,要先踏下离合踏板,使齿轮啮合松开后再踩制动踏板。这样可以减少新车发动机、制动系统、底盘的中击损伤。但是这种"先离后刹”的方法是不符合驾车规范的,它限于处于磨合时期的车辆。
4、 The brake is separated and engaged. When the small mixer is braking, press the clutch pedal first to release the gear engagement and then press the brake pedal. This can reduce the impact damage of the engine, brake system and chassis of the new car. However, this method of "leaving first and braking later" is not in line with the driving regulations. It is limited to vehicles in the run-in period.
在度过磨合期后,从离合器的保养方面,我们还是应该"先刹后离”。我们也听到过不少的新手,在开车的初期总是把脚放在离合器上,刹车前要先把踏板踏下去。有的人还为了换挡的方便'脚不离板。的确。对新手来说,这样开车可以把车开得更平稳些,但对离合器的磨损可不小。
After the running-in period, we should still "brake first and then leave" in terms of clutch maintenance. We have also heard that many novices always put their feet on the clutch at the beginning of driving, and put the pedal down before braking. Some people also keep their feet on the pedal for the convenience of gear shifting. Indeed, for novices, driving in this way can drive the car more smoothly, but the wear on the clutch is not small.
不论是老司机还是新司机,搅拌车在磨期的各种保养一定要注意。不要因小失大,磨合期的一些正确习惯都是为了车辆以后更好的为我们服务。磨合期做好,以后搅拌车会更省油而且开车时也特别轻松。更多相关事项就来我们网站https://www.jfjiaobanche.com咨询吧！
Both old and new drivers must pay attention to the various maintenance of the mixer during the grinding period. Don't lose everything. Some of the correct habits in the run-in period are for the vehicle to serve us better in the future. The running-in period should be done well, and the mixer will save more fuel in the future, and it will be especially easy to drive. Come to our website for more relevant matters https://www.jfjiaobanche.com Ask!
下一篇：搅拌车从出车到卸料的全程关注事项上一篇：如何上料搅拌车方向盘不稳的问题
