自上料搅拌车需检查一些“硬核”问题
自上料搅拌车的使用过程也不一定都很顺利，尤其是您在驾驶工作前做好相应检查的话，非常容易就会出现各种样式的问题故障，下面自上料搅拌车厂家来讲讲设备需检查一些“硬核”问题。
The use process of the self feeding mixer is not always smooth, especially if you do a good job in the corresponding inspection before driving, it is very easy to have various types of problems and failures. Now let's talk about some "hard core" problems that need to be checked for the equipment from the manufacturer of the self feeding mixer.
1、控制气压紧固接头.罐体内应该打进多少的气压，这个在出厂的时候已经设定好，不需自己调节。如果遇上特殊情况非要调节，建议压力控制在3.5Mpa左右，压力太大容易爆管。另外，新的自上料搅拌车以及日常使用中，要对管路接口的地方随时紧固，防落。
1. Control air pressure fastening connector How much air pressure should be injected into the tank, which has been set at the factory, does not need to be adjusted. If it is necessary to adjust under special circumstances, it is recommended to control the pressure at about 3.5Mpa. If the pressure is too high, the pipe will burst easily. In addition, the new self feeding mixer truck and its daily use shall be fastened at any time at the pipe interface to prevent falling off.
2、罐车加水流程.每种罐车加水处的布置都大同小异，一般都是水罐排气——加满水——关闭加水阀;在不用的情况下，将拨杆的位置放在中间。
2. Water filling process of tank car The arrangement of water filling places of each type of tank car is much the same with little difference. Generally, the water tank exhausts - fills up the water - closes the water filling valve; When not in use, place the paddle in the middle.
3、冬季排尽管内余水.在冬季每天收车之后应该排尽水罐内和水管中的水，并在水管打入压缩空气吹尽各个管路中残留的水，防止因为结冰造成管路冻裂。水泥自上料搅拌车
3. In winter, there is no water left inside In winter, the water in the water tank and water pipe shall be drained after the vehicle is collected every day, and compressed air shall be injected into the water pipe to blow away the residual water in each pipe, so as to prevent the pipe from freezing and cracking. Cement self loading mixer
4、随车带上减水剂，减水剂是一种在维持混凝土坍落度不变的条件下，能减少拌合用水量的混凝土外加剂，随车携带，能对混凝土进行很好的调节。不过在加入减水剂的时候，一定要记得有商砼站化验室的人在场，否则混凝土质量强度不够，驾驶员要承担后果。
4. The water reducing agent is a concrete additive that can reduce the mixing water consumption under the condition that the concrete slump remains unchanged. It is carried with the vehicle and can adjust the concrete well. However, when adding water reducing agent, be sure to remember that there are people in the laboratory of the commercial concrete station, otherwise the concrete quality and strength are not enough, and the driver will bear the consequences.
5、回厂检查罐内水量.每次出车任务完成回到站内的时候，检查储水罐内的水量，让水罐中的水随时处于满罐的状态，以备不时之需。
5. Return to the factory to check the water volume in the tank When returning to the station after completing the task of driving, check the water volume in the water storage tank to keep the tank full at any time for emergency.
6、离厂前检查混凝土质量。可能会因为原料的不同，每一盘混凝土质量都会有变化。在装好混凝土离场时，一定要检查罐内混凝土的塌落度情况以及和易度，小心混凝土的提前凝结和混凝土分层沉淀。
6. Check the concrete quality before leaving the factory. The quality of each plate of concrete may change due to different raw materials. When the concrete is loaded and leaving the site, it is necessary to check the slump and workability of the concrete in the tank, and be careful of the early setting and layered precipitation of the concrete.
7、减少车辆行驶时间.混凝土运距一般在直径30范围以内，出车之前规划好路线以及车辆通行情况，尽量减少车辆在路上的时间。
7. Reduce vehicle travel time The transportation distance of concrete is generally within the range of 30km in diameter, and the route and traffic conditions of vehicles shall be planned before departure to minimize the time of vehicles on the road.
8、减少损失先卸料.如果遇到人为因素或者不可抗因素，导致长时间无法卸料的情况，应随时查看罐内混凝土情况，一旦发现混凝土开始凝结。在报备负责人之后立刻进行卸料，以防整个罐体报废。
8. Unload first to reduce losses In case of human factors or irresistible factors that make it impossible to unload materials for a long time, the concrete in the tank shall be checked at any time. Once it is found that the concrete starts to set. Unload immediately after reporting to the person in charge to prevent the whole tank from being scrapped.
9、随时需清洗.运营当中随时冲洗。在每次卸料之后，用罐车自己带水枪对罐口、叶片、进料口、罐体以及犄角旮旯进行冲洗，防止混凝土凝固之后越积越多，不好清理。
9. Clean at any time Rinse at any time during operation. After each unloading, use the tanker with its own water gun to wash the tank mouth, blade, feed inlet, tank body and corners to prevent the concrete from accumulating more after solidification, which is difficult to clean.
要注意，收车之后清洗罐车。每天的运送任务结束之后，在罐内加入1立方米以上的清水，快速的旋转罐体进行清洗。有条件的公司，还可以在罐内加入石子，效果会更好。更多使用注意事项就来我们网站https://www.jfjiaobanche.com进行咨询吧！
Please note that the tank car shall be cleaned after the car is collected. At the end of the daily delivery task, add more than 1 cubic meter of clean water into the tank and quickly rotate the tank for cleaning. If conditions permit, you can also add stones in the tank to achieve better results. More usage precautions come to our website https://www.jfjiaobanche.com Consult!
下一篇：全自动搅拌车应遵守的操作规范上一篇：混凝土自上料搅拌车叶片故障的维修
