影响自上料搅拌机使用年限的是什么？
1.吊杆是加料搅拌器重要的结构部件。一旦吊杆损坏或使用寿命结束，喂料搅拌器就失去了原来的意义。泵车没有吊杆，我想只能叫车泵。因此，吊杆的使用寿命直接决定了加料搅拌车装载部分的使用寿命。
1. The boom is an important structural component of the charging mixer. Once the boom is damaged or the service life is over, the feed mixer loses its original meaning. The pump truck has no boom. I think I can only call the pump truck. Therefore, the service life of the boom directly determines the service life of the loading part of the charging mixer truck.
2.臂架的使用寿命长取决于臂架采用高强度钢，采用较轻的设计，并优化泵送系统的压力，减少泵送混凝土对臂架的影响。同时，对手臂的日常保养和保养，也是提高手臂使用寿命的关键。因为更换手臂的费用太高，所以，当多节手臂在出现损坏时，有些人宁愿选择放弃对其进行保养。在那一点上，自装混合器的生命结束了。
2. The long service life of the boom depends on the use of high-strength steel and lighter design, and optimize the pressure of the pumping system to reduce the impact of pumping concrete on the boom. At the same time, the daily maintenance of the arm is also the key to improve the service life of the arm. Because the cost of replacing the arm is too high, some people prefer to give up maintenance when multiple arms are damaged. At that point, the life of the self-contained mixer is over.
3.底盘从进料混合器的重要性是不言而喻的，如果底盘不能正常工作，也不能为安装的液压系统提供动力，这时，也只能选择报废。要延长底盘的使用寿命，关键的还是定期保养。同时，一些坏习惯应该避免在日常驾驶。例如，空转的出租车，对于泵车等重车来说，是对变速箱非常损坏的。因此，底盘的使用寿命也可能与驾驶员的驾驶方式有关。
3. The importance of the chassis from the feed mixer is self-evident. If the chassis cannot work normally or provide power for the installed hydraulic system, it can only be scrapped. To prolong the service life of the chassis, the key is regular maintenance. At the same time, some bad habits should be avoided in daily driving. For example, an idle taxi is very damaged to the gearbox for heavy vehicles such as pump trucks. Therefore, the service life of the chassis may also be related to the driving style of the driver.
全自动搅拌车厂家分享变速箱的保养1. 正确把握自动上料搅拌车变速箱油的使用周期，定期更换。一般情况下，大多数厂家都会建议变速器换油周期一般为2年或4万6万。当使用车主朋友保持传动油的清洁,因为变速箱油使用很长一段时间后会发生油垢,可能会形成污泥,会增加摩擦磨损的部分,还会使身体运动的阀体,液压控制,使自动混合汽车变速器异常。
Maintenance of transmission 1 Correctly grasp the service cycle of gearbox oil of automatic feeding mixer truck and replace it regularly. Generally, most manufacturers will recommend that the oil change cycle of the transmission is generally 2 years or 40000 to 60000 km. When using the vehicle owner's friend, keep the transmission oil clean, because the transmission oil will produce oil dirt after being used for a long time, which may form sludge, increase the friction and wear parts, and make the body move the valve body and hydraulic control, making the automatic hybrid vehicle transmission abnormal.
2. 经常检查变速器油位是否正常。检查传动油需要预热50℃左右,然后把杆在每一站停车后2秒,目前正常的油位应位于和之间的线,如果没有达到,应及时添加相同的油质量。
2. Always check whether the transmission oil level is normal. Check that the transmission oil needs to be preheated to about 50 ℃, and then stop the rod at each station for 2 seconds. At present, the normal oil level should be between the highest and lowest line. If it is not reached, the same oil quality should be added in time.
3.正确更换变速箱油。动态换油目前更提倡换油的方法,选择特殊的齿轮箱清洗设备,在传播的过程中工作,旧的油将完整的循环,排出干净然后参与新变速器油,这样换油率高达90,以确保的换油。
3. Replace the transmission oil correctly. At present, dynamic oil change advocates the method of oil change. Select special gearbox cleaning equipment to work in the process of transmission. The old oil will circulate completely and be discharged, and then participate in the new transmission oil. In this way, the oil change rate is as high as 90 to ensure efficient oil change.
